http://ccnaanswers.com/wp-content/up....0Answers5.jpg
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technician enters the following set of commands on the router:
Sanford(config)# interface loopback1
Sanford(config-if)# ip address 192.168.6.62 255.255.255.252
Why does the router respond with an error?
A-The router does not allow loopback interface configurations.
B-This mask can not be used with this class of addresses.
C-Classless routing must be configured before this address can be added.
D-The network address for Loopback1 overlaps with an already configured interface address.
E-The router is over the limit for the maximum paths that can be provided in the routing table.
الاجابة الصحيحة هيا D
لكن ما فهمت السؤال ؟
ملاحظة
السؤال تابع للصورة الموجودة بالرابط *
A___البرمجة-البريد الإلكتروني-نظم التشغيل-الكمبيوتر والإنترنت
أكثر...
ضوابط المشاركة
رد مع اقتباس